UL iQ鈩�
for enhanced search functionality please visit UL's iQ鈩� family of databases Component - Photovoltaic Polymeric Materials E321543 HONEYWELL INTERNATIONAL INC 98 WESTWOOD RD, POTTSVILLE PA 17901 PV 270 (a)(b)(c) ECTFE/PET/PE-EVA, "Powershield", Photovoltaic Backsheets, furnished as sheets or roll Air-sideCell-sideNom ThkFlame RTIRTI ColorColor(mm)ClassHWIHAIElecStr WTWT0.270RP50-0-- Comparative Tracking Index (CTI):0Inclined Plane Tracking (IPT):- Dielectric Strength (kV/mm):-Volume Resistivity (10x ohm-cm) :- High-Voltage Arc Tracking Rate (HVTR):-High Volt, Low Current Arc Resis (D495):- Dimensional Stability (%):- (a) - RADIANT PANEL, ASTM E162: Actual average value test values of RP23 (b) - LIQUID CONTAMINANT, INCLINED-PLANE TRACKING TEST: time to track 25 mm was 119 minutes for air-side surface (c) - PARTIAL DISCHARGE TEST: The mean value of the extiction voltage minus the standard deviation of the extinction voltage is greater than 1.5 times the given maximum system voltage of 1000V. ANSI/UL 94 small-scale test data does not pertain to building materials, furnishings and related contents. ANSI/UL 94 small-scale test data is intended solely for determining the flammability of plastic materials used in the components and parts of end-product devices and appliances, where the acceptability of the combination is determined by UL. Report Date: 2009-10-24 Last Revised: 2012-12-12 漏 2014 UL LLC IEC and ISO Test Methods Thickness Test NameTest MethodUnitsTested (mm)Value FlammabilityClass (color)- Glow-Wire Flammability (GWFI)IEC 60695-2-12C-- Glow-Wire Ignition (GWIT)IEC 60695-2-13C-- IEC Partial DischargeIEC 61730-2, MST 15Max System Voltage (V)-- IEC Comparative Tracking IndexIEC 60112Volts (Max)3.0CTI600 IEC Ball PressureIEC 60695-10-2C-- ISO Heat Deflection (1.80 MPa)ISO 75-2C-- ISO Tensile StrengthISO 527-2MPa-- ISO Flexural StrengthISO 178MPa-- ISO Tensile ImpactISO 8256kJ/m2-- ISO Izod ImpactISO 180kJ/m2-- ISO Charpy ImpactISO 179-2kJ/m2-- 漏 2014 UL LLC The materials covered in this database are incomplete in certain constructional features or restricted in performance capabilities and are intended for use as components of complete equipment submitted for investigation rather than for direct separate installation in the field. THE FINAL ACCEPTANCE OF THE COMPONENT IS DEPENDENT UPON ITS INSTALLATION AND USE IN COMPLETE PRODUCTS SUBMITTED TO UNDERWRITERS LABORATORIES. Notice of Disclaimer